Exide ET9B-BS · Motorcycle battery 12V 8Ah 110A AGM
Specifications
| Brand | EXIDE |
|---|---|
| Part number | ET9B-BS |
| Voltage (V) | 12 |
| Capacity (C20) | 8Ah (c20) |
| Technology | AGM |
| Length | 150.00 cm |
| Width | 70.00 cm |
| Height | 105.00 cm |
| Weight | 2.90 Kgs |
€30.70
VAT included
Exide ET9B-BS 12V 8Ah 110A is a sealed motorcycle battery ready to fit, with the JIS reference your mechanic recognises at a glance. Vibration-resistant, keeps voltage during the winter off-season and cranks first time when you take it out for a ride.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season
JIS code
ET9B-BS
Voltage
12 V
Capacity
8 Ah
Cold cranking
110 A
Dimensions
150×70×105 mm
Technology
AGM
Polarity
Positive on the left
Weight
2,9 kg
Model
EXIDE MOTO AGM 12V
Mfr. reference
ET9B-BS
Motorcycle battery Exide ET9B-BS Moto AGM 8Ah 110A 12V
12VVoltage
8AhCapacity
110ACold cranking
2.90kgWeight
With 8 Ah at 12 V and 110 A of cold cranking current (EN), the Exide ET9B-BS with AGM technology replaces the original battery of motorcycles, scooters, quads and personal watercraft. Measuring 150 × 70 × 105 mm and the positive terminal on the left, it is the direct replacement for motorcycles fitted from the factory with a 8 Ah battery of this format.
- Holds its charge through winter storage.
- Compact and lightweight format.
- AGM: faster recharging and better cycle resistance than a conventional battery.
- Sealed and ready to fit, no acid handling.
Will it fit your current battery tray?
The Exide ET9B-BS is made in the 150 × 70 × 105 mm format and weighs 2.90 kg. The positive terminal on the left decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. It uses a B0 hold-down and M04 terminals, the system that anchors and connects it in the vehicle. For a direct replacement, the current battery tray must accept these dimensions and the same terminal layout; otherwise adapters will be needed or the hold-down will change.
What the Exide ET9B-BS is for
The Exide ET9B-BS is a common replacement in motorcycles, scooters, quads and personal watercraft. If your bike spends the winter standing, a trickle charger stops it reaching spring flat. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 2.90 kg, M04 terminals and B0 hold-down.
The Exide ET9B-BS: Moto AGM range and AGM technology
The ET9B-BS is part of the Exide Moto AGM range. Choosing the right reference within the series comes down to capacity, dimensions and terminals: technology and quality are common to the whole family.
In an AGM battery the electrolyte is absorbed in glass-fibre separators: there is no free liquid, it cannot spill and it can be mounted at an angle. That construction lowers internal resistance, speeds up recharging and multiplies cycle life compared with a conventional battery.
What Exide does differently
With more than a century of history, Exide Technologies manufactures automotive, marine, motorcycle and industrial batteries in Europe. Its presence as original equipment on assembly lines vouches for the quality of every reference. We guarantee that every Exide arrives new, charged and with the manufacturer's full warranty.
Warranty and coverage
The Exide ET9B-BS comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
How to make it last longer
Avoid repeated cranking attempts on a cold bike for long: if it does not start on the third try, let the battery rest for a minute. Check the resting voltage before the season (above 12.6 V on a charged battery) and make sure the terminals are clean and tight.
When you get it and how to return it
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-EXIDE-ET9B-BS
Data sheet
- Brand
- EXIDE
- Reference
- ET9B-BS
- Model
- EXIDE MOTO AGM 12V
- Voltage (V)
- 12
- Length
- 150.00 cm
- Width
- 70.00 cm
- Height
- 105.00 cm
- Weight
- 2.90 Kgs
- Technology
- AGM
- EAN
- 3661024033916
- Terminal layout
- Positive terminal on the left
- Terminal type
- M04
- Hold-down
- B0
- Cold cranking amps (EN)
- 110A
- Capacity (C20)
- 8Ah (c20)
Specific References
- EAN13
- 3661024033916
- MPN
- ET9B-BS
Codes and references Exide ET9B-BS
| Brand | Exide · see all batteries Exide |
|---|---|
| Manufacturer range | EXIDE MOTO AGM 12V |
| Manufacturer reference (MPN) | ET9B-BS |
| EAN-13 barcode | 3661024033916 |
| Dimensions (length × width × height) | 150 × 70 × 105 mm (150x70x105) |
Comparison: Exide ET9B-BS vs equivalents
The Exide ET9B-BS is interchangeable with these equivalent references: 509902008 (Varta).
| Product | Specifications | Technology | Price |
|---|---|---|---|
Exide
ET9B-BS
This battery
|
12V 8Ah 110A | AGM | €30.70 |
Varta
509902008
|
12V 8Ah 115A | AGM | €93.10 |
Equivalences verified by our technical team: same dimensions, polarity, capacity and CCA. Official manufacturer warranty on every option.
Recommended accessories
How to change the battery
Guide to replace your motorcycle battery in 10-15 minutes. Motorcycle batteries are light (2-5 kg) and usually need an 8 mm wrench.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
On motorcycles it is usually under the seat, in the rear cowl or behind a side panel. Check the manual — access varies a lot between models.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Loosen the hold-down clamp or the straps that secure it. Lift the battery carefully — typical weight 2-5 kg. Check the terminals are not corroded before fitting the new one.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify the engine starts
Close the bonnet. Start the engine to confirm everything works. On cars with Start-Stop or a BMS, you may need to register the battery via OBD so the alternator applies the correct charging profile.
Frequently asked questions
Is the Exide ET9B-BS an AGM battery and what are the benefits of AGM?
Yes. The ET9B-BS from Exide uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for motorcycles with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How is the Exide ET9B-BS battery installed in the vehicle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the ET9B-BS model?
Expected lifespan of the Exide ET9B-BS is 5 to 8 years in mild-climate motorcycle use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Exide ET9B-BS battery?
Dimensions (length × width × height) are 150×70×105 mm — also written as 150x70x105 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Will the Exide ET9B-BS battery fit my motorcycle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The ET9B-BS typically fits a wide range of European vehicles thanks to its standard DIN case format.
Which batteries are equivalent to the Exide ET9B-BS?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.