Fulbat FLP12-36 · Mobility scooter battery 12.8V 36Ah LiFePO4
Specifications
| Brand | FULBAT |
|---|---|
| Part number | FLP12-36 |
| Voltage (V) | 12.80V |
| Capacity (C20) | 36Ah |
| Technology | LiFePO4 |
| Length | 195mm |
| Width | 130mm |
| Height | 162mm |
| Terminal layout | Positive left |
This product is priced on demand to offer you the best available price at all times.
Please contact us to request a quote and we will inform you about availability and the best price on the entire website, as well as the delivery time.
Thank you
Fulbat FLP12-36 12.8V 36Ah is a deep-cycle battery optimised for repeated discharges down to 80 % DOD and thousands of life cycles. Ideal when the battery discharges and recharges daily rather than just cranking the engine (mobility scooters, backup systems, golf, pallet trucks).
Why this deep-cycle battery?
- Daily cycling without wearhandles deep discharges without losing capacity
- Sealed AGM/GELno maintenance, no risk of spills
- Thousands of useful cyclesover its full lifetime
Voltage
12.8 V
Capacity
36 Ah
Dimensions
195×130×162 mm
Technology
Lithium (LiFePO4)
Polarity
Positive on the left
Free quote, no obligation
Request a quote for your Mobility scooter battery Fulbat FLP12-36 12.8V 36Ah LiFePO4
- Reply in under 24 working hours
- Best price guaranteed
Mobility battery Fulbat FLP12-36 36Ah 12.8V
12.8VVoltage
36AhCapacity
Designed for power wheelchairs, mobility scooters and light electric vehicles, the Fulbat FLP12-36 offers 36 Ah of deep-cycle capacity with LiFePO4 lithium technology. Measuring 195 × 130 × 162 mm and the positive terminal on the left, it is the direct replacement for power wheelchairs and mobility scooters fitted from the factory with a 36 Ah battery of this format.
- Built-in BMS protecting the battery and the vehicle.
- Sealed AGM/GEL: safe indoors and in transport.
- No maintenance, no water top-ups.
- Approved for air and sea transport (VRLA).
What the Fulbat FLP12-36 is for
The Fulbat FLP12-36 is designed for power wheelchairs, mobility scooters and light electric vehicles. Wheelchairs and scooters normally use two identical batteries in series: replace them together. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has BOLT-M6 terminals.
Technology inside the Fulbat FLP12-36
Fulbat builds the FLP12-36 to the same standards as the rest of its catalogue; what changes between references is capacity, format and terminal position.
A LiFePO4 battery starts with the same nominal voltage as a lead-acid one but with far less weight and a service life several times longer. It requires a lithium-compatible charger.
Size, terminals and hold-down of the Fulbat FLP12-36
The Fulbat FLP12-36 is made in the 195 × 130 × 162 mm format. The positive terminal on the left decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. It uses BOLT-M6 terminals, the system that anchors and connects it in the vehicle. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
Fulbat: the maker behind the FLP12-36
Fulbat has manufactured in France since 1978 and specialises in motorcycles and light vehicles. Its catalogue is short and clear, covers almost the whole fleet and works only with sealed, leak-free batteries. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
How to make it last longer
Recharge the wheelchair or scooter after each use and do not leave it discharged for days: lead sulphates and loses capacity. Store the battery at 50-70% charge if it will be unused for months.
Manufacturer's warranty
The Fulbat FLP12-36 comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
Shipping, delivery and returns
Same-day dispatch from our warehouse for in-stock orders placed before 6:00 pm: 24-48 working hours in mainland Spain and Portugal, 3 to 5 days in the islands and the rest of Europe. Returns are accepted for 14 days if the battery has not been used (free collection on the Iberian mainland). You will receive tracking by email.
BCOM-FULBAT-FLP12-36
Data sheet
- Brand
- FULBAT
- Model
- FULBAT FLP Cyclic LiFePO4
- Voltage (V)
- 12.80V
- Length
- 195mm
- Width
- 130mm
- Height
- 162mm
- Technology
- LiFePO4
- Terminal layout
- Positive left
- Terminal type
- BOLT-M6
- Capacity (C20)
- 36Ah
Specific References
- MPN
- FLP12-36
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
How is the Fulbat FLP12-36 battery installed in the vehicle?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Fulbat FLP12-36 is 4 to 7 years in regular use (depends on technology and climate). In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the measurements of the FLP12-36 model?
Dimensions (length × width × height) are 195×130×162 mm — also written as 195x130x162 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which batteries are equivalent to the Fulbat FLP12-36?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.