Fullriver FFD35-12 · Marine battery 12V 35Ah 225A AGM
Specifications
| Brand | FULLRIVER |
|---|---|
| Part number | FFD35-12 |
| Voltage (V) | 12 |
| Capacity (C20) | 35 |
| Capacity (C5) | 29 Ah (c5) |
| Technology | AGM |
| Length | 196.00 cm |
| Width | 131.00 cm |
| Height | 167.00 cm |
€200.30
VAT included
Fullriver FFD35-12 12V 35Ah 225A is a marine battery with reinforced anti-vibration case for moorings and offshore use. Tolerates the typical daily cycles on a boat (engine start + night-time services such as lights, sonar, fridge) and holds voltage even when the hull is rolling in open sea.
Why this marine battery?
- Marine designbuilt for boat swell and vibration
- Dual functionstarts the engine and powers onboard services
- Sealed and safemaintenance-free even when the boat rolls
Voltage
12 V
Capacity
35 Ah
Cold cranking
225 A
Dimensions
196×131×167 mm
Technology
AGM
Weight
9,9 kg
Model
FULLRIVER FF
Marine battery Fullriver FFD35-12 Full Force Series 35Ah 225A 12V
12VVoltage
35AhCapacity
225ACold cranking
9.90kgWeight
The Fullriver FFD35-12 marine battery offers 12 V, 35 Ah and 225 A of cold cranking current (EN) from the Full Force Series range with AGM technology, designed for motor and sailing boats, both for engine starting and onboard services. Its 196 × 131 × 167 mm make it the exact replacement for the 35 Ah battery fitted as standard to many boats.
- Ready for starting outboard and inboard engines.
- AGM: faster recharging and better cycle resistance than a conventional battery.
- Resistant to humidity and salt air.
- Sealed: no spills or gases in the locker.
What the Fullriver FFD35-12 is for
The Fullriver FFD35-12 is designed for motor and sailing boats, both for engine starting and onboard services. If it is your starter battery, run the services from a separate battery; if it is a service battery, avoid routinely discharging it beyond 50%. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 9.90 kg and M6 terminals.
Dimensions, polarity and mounting
It has external dimensions of 196 × 131 × 167 mm and weighs 9.90 kg. It uses M6 terminals, the system that anchors and connects it in the vehicle. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
Fullriver: the maker behind the FFD35-12
With its own plants and a catalogue focused on high-performance AGM, Fullriver is a familiar brand in power wheelchairs, boats and photovoltaic systems that need thousands of cycles. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
The Fullriver FFD35-12: Full Force Series range and AGM technology
The FFD35-12 is part of the Fullriver Full Force Series range. Choosing the right reference within the series comes down to capacity, dimensions and terminals: technology and quality are common to the whole family.
AGM (Absorbent Glass Mat) technology seals the electrolyte in glass microfibre. The result is a maintenance-free battery that is highly vibration-resistant and able to withstand deep discharges that would ruin a classic lead-acid battery.
Care and maintenance
At the end of the season, charge the battery fully and, if possible, keep it on a charger over the winter lay-up. Protect the terminals with dielectric grease and check the fixing: vibration and swell loosen connections.
Official warranty
The Fullriver FFD35-12 comes with the manufacturer's official warranty against manufacturing defects. Deep discharge from winter lay-up without charging is not covered.
Shipping, delivery and returns
Same-day dispatch from our warehouse for in-stock orders placed before 6:00 pm: 24-48 working hours in mainland Spain and Portugal, 3 to 5 days in the islands and the rest of Europe. Returns are accepted for 14 days if the battery has not been used (free collection on the Iberian mainland). You will receive tracking by email.
BCOM-FULLRIVER-FFD35-12
Data sheet
- Brand
- FULLRIVER
- Reference
- FFD35-12
- Model
- Full Force Series
- Voltage (V)
- 12
- Length
- 196.00 cm
- Width
- 131.00 cm
- Height
- 167.00 cm
- Weight
- 9.90 Kgs
- Technology
- AGM
- EAN
- 131843
- Terminal type
- M6
- Cold cranking amps (EN)
- 225
- Capacity (C20)
- 35
- Case type
- U1
- Capacity (C5)
- 29 Ah (c5)
Specific References
- MPN
- FFD35-12
Comparison: Fullriver FFD35-12 vs equivalents
The Fullriver FFD35-12 is interchangeable with these equivalent references: DC35-12A (Fullriver).
| Product | Specifications | Technology | Price |
|---|---|---|---|
Fullriver
FFD35-12
This battery
|
12V 35Ah 225A | AGM | €200.30 |
Fullriver
DC35-12A
|
12V 35Ah 190A | AGM | €140.40 |
Equivalences verified by our technical team: same dimensions, polarity, capacity and CCA. Official manufacturer warranty on every option.
Recommended accessories
How to change the battery
Guide to replace a marine battery (cranking or house) in 20-30 minutes. Moisture and vibration in marine environments require reinforced hold-downs and sealed copper terminals.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
Usually under the passenger bench, engine room or a dedicated ventilated compartment. Verify the compartment is dry and well ventilated before opening.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Marine batteries are heavy (15-50 kg). If it has rope handles, use them; otherwise have a carry strap ready. Secure the new one with metal hold-downs (not plastic) to resist sea-state vibration.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify circuit + water protection
Apply dielectric grease on terminals to prevent salt-air corrosion. Check the engine charging circuit delivers 13.8-14.4 V at 2,000 rpm.
Frequently asked questions
Is the Fullriver FFD35-12 an AGM battery and what are the benefits of AGM?
Yes. The FFD35-12 from Fullriver uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for boats with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I fit the FFD35-12 model in my boat?
In most boats it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On boats with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Fullriver FFD35-12 is 5 to 8 years in mild-climate boat use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Fullriver FFD35-12 battery?
Dimensions (length × width × height) are 196×131×167 mm — also written as 196x131x167 mm — following the European DIN standard. Always measure the space in your boat before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Does this battery fit my boat?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The FFD35-12 typically fits a wide range of European vehicles thanks to its standard DIN case format.
What are the equivalents of the FFD35-12 model?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop boats. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.