Fullriver FT560 · Marine battery 12V 44Ah 560A AGM
Specifications
| Brand | FULLRIVER |
|---|---|
| Part number | FT560 |
| Voltage (V) | 12 |
| Capacity (C20) | 44 |
| Cold cranking amps (EN) | 560 |
| Technology | AGM |
| Length | 198.00 cm |
| Width | 166.00 cm |
| Height | 180.00 cm |
€221.50
VAT included
Fullriver FT560 12V 44Ah 560A is a marine battery with reinforced anti-vibration case for moorings and offshore use. Tolerates the typical daily cycles on a boat (engine start + night-time services such as lights, sonar, fridge) and holds voltage even when the hull is rolling in open sea.
Why this marine battery?
- Marine designbuilt for boat swell and vibration
- Dual functionstarts the engine and powers onboard services
- Sealed and safemaintenance-free even when the boat rolls
Voltage
12 V
Capacity
44 Ah
Cold cranking
560 A
Dimensions
198×166×180 mm
Technology
AGM
Weight
15,1 kg
Model
Full Throttle Series
Marine battery Fullriver FT560 Full Throttle Series 44Ah 560A 12V
12VVoltage
44AhCapacity
560ACold cranking
15.10kgWeight
The Fullriver FT560 marine battery offers 12 V, 44 Ah and 560 A of cold cranking current (EN) from the Full Throttle Series range with AGM technology, designed for motor and sailing boats, both for engine starting and onboard services. It measures 198 × 166 × 180 mm, the format sought by anyone replacing a 44 Ah battery in boats.
- Reinforced case against vibration and swell.
- AGM technology: absorbed electrolyte, no spills, can be mounted at an angle.
- Tolerates the daily cycling of a boat in season.
- Powers onboard services: lights, sounder, GPS, fridge.
What the Fullriver FT560 is for
On board, the Fullriver FT560 provides 44 Ah with a case reinforced against vibration and swell. Keep the terminals clean and protected from salt humidity. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 15.10 kg and M6 + TP26 (SAE) terminals.
Will it fit your current battery tray?
The Fullriver FT560 is made in the 198 × 166 × 180 mm format and weighs 15.10 kg. It uses M6 + TP26 (SAE) terminals, the system that anchors and connects it in the vehicle. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
The Fullriver FT560: Full Throttle Series range and AGM technology
The FT560 is part of the Fullriver Full Throttle Series range. Choosing the right reference within the series comes down to capacity, dimensions and terminals: technology and quality are common to the whole family.
AGM means the acid is held in a glass mat instead of floating free. That is why the battery can be installed in the cabin without gases, survives more cycles and recovers its charge quickly.
Fullriver: the maker behind the FT560
Fullriver specialises in deep-cycle AGM batteries for mobility, marine, solar and traction. Its DC and HC series are known for their tolerance to deep discharge and long cycle life. All the Fullriver batteries in our catalogue are genuine product, recently manufactured and covered by the manufacturer's warranty.
Warranty and coverage
The Fullriver FT560 comes with the manufacturer's official warranty against manufacturing defects. Deep discharge from winter lay-up without charging is not covered.
Usage and maintenance tips
Charge with a charger that has an AGM mode: it limits the voltage and protects the glass-fibre separators. As a service battery, avoid routine discharges below 50% to extend its cycle life.
Delivery times and returns
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-FULLRIVER-FT560
Data sheet
- Brand
- FULLRIVER
- Reference
- FT560
- Model
- Full Throttle Series
- Voltage (V)
- 12
- Length
- 198.00 cm
- Width
- 166.00 cm
- Height
- 180.00 cm
- Weight
- 15.10 Kgs
- Technology
- AGM
- EAN
- 810233030442
- Terminal type
- M6 + TP26 (SAE)
- Cold cranking amps (EN)
- 560
- Capacity (C20)
- 44
- Case type
- 26R
Specific References
- UPC
- 810233030442
- EAN13
- 810233030442
- MPN
- FT560
Codes and references Fullriver FT560
| Brand | Fullriver |
|---|---|
| Manufacturer range | Full Throttle Series |
| Manufacturer part number (MPN) | FT560 |
| EAN-13 barcode | 810233030442 |
| Dimensions (length × width × height) | 198 × 166 × 180 mm (198x166x180) |
Comparison: Fullriver FT560 vs equivalents
The Fullriver FT560 is interchangeable with these equivalent references: FT560L (Fullriver).
| Product | Specifications | Technology | Price |
|---|---|---|---|
Fullriver
FT560
This battery
|
12V 44Ah 560A | AGM | €221.50 |
Fullriver
FT560L
|
12V 44Ah 560A | AGM | €221.50 |
Equivalences verified by our technical team: same dimensions, polarity, capacity and CCA. Official manufacturer warranty on every option.
Recommended accessories
How to change the battery
Guide to replace a marine battery (cranking or house) in 20-30 minutes. Moisture and vibration in marine environments require reinforced hold-downs and sealed copper terminals.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
Usually under the passenger bench, engine room or a dedicated ventilated compartment. Verify the compartment is dry and well ventilated before opening.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Marine batteries are heavy (15-50 kg). If it has rope handles, use them; otherwise have a carry strap ready. Secure the new one with metal hold-downs (not plastic) to resist sea-state vibration.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify circuit + water protection
Apply dielectric grease on terminals to prevent salt-air corrosion. Check the engine charging circuit delivers 13.8-14.4 V at 2,000 rpm.
Frequently asked questions
Is the Fullriver FT560 an AGM battery and what are the benefits of AGM?
Yes. The FT560 from Fullriver uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for boats with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I change this battery step by step?
In most boats it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On boats with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the FT560 model?
Expected lifespan of the Fullriver FT560 is 5 to 8 years in mild-climate boat use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the measurements of the FT560 model?
Dimensions (length × width × height) are 198×166×180 mm — also written as 198x166x180 mm — following the European DIN standard. Always measure the space in your boat before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Will the Fullriver FT560 battery fit my boat?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The FT560 typically fits a wide range of European vehicles thanks to its standard DIN case format.
Which batteries are equivalent to the Fullriver FT560?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop boats. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.