Fullriver HC110 · Wheelchair battery 12V 110Ah 1100A AGM
Specifications
| Brand | FULLRIVER |
|---|---|
| Part number | HC110 |
| Voltage (V) | 12 |
| Capacity (C20) | 110Ah (c20) |
| Technology | AGM |
| Length | 330.00 mm |
| Width | 173.00 mm |
| Height | 237.00 mm |
| Weight | 20.70 Kgs |
€679.20
VAT included
4,73/5★★★★★13 reviewsVerified purchases
- ★★★★★Jose Manuel Vicente:
No tenía ni idea de cómo instalar la batería en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
- ★★★★★Jose Carlos Gallardo:
Me ayudaron con la instalación de mi batería
- ★★★★Jaime PeÑa:
Si tienes dudas con la instalación puedes llamar y te asesoran.
Fullriver HC110 12V 110Ah 1100A is a deep-cycle battery for wheelchairs and mobility scooters, optimised to be discharged and recharged daily down to 80 % DOD without losing range.
Why this wheelchair battery?
- Daily cycling without wearhandles deep discharges without losing capacity
- Sealed AGM/GELno maintenance, no risk of spills
- Thousands of useful cyclesover its full lifetime
Voltage
12 V
Capacity
110 Ah
Cold cranking
1100 A
Dimensions
330×173×237 mm
Technology
AGM
Weight
20,7 kg
Model
FULLRIVER HC
Mobility battery Fullriver HC110 HC 110Ah 1,100A 12V
12VVoltage
110AhCapacity
1,100ACold cranking
20.70kgWeight
Designed for power wheelchairs, mobility scooters and light electric vehicles, the Fullriver HC110 from the HC range offers 110 Ah of deep-cycle capacity with AGM technology. Its 330 × 173 × 237 mm make it the exact replacement for the 110 Ah battery fitted as standard to many power wheelchairs and mobility scooters.
- Approved for air and sea transport (VRLA).
- No maintenance, no water top-ups.
- Sealed AGM/GEL: safe indoors and in transport.
- AGM: faster recharging and better cycle resistance than a conventional battery.
What the Fullriver HC110 is for
The Fullriver HC110 is the usual replacement in power wheelchairs, mobility scooters and light electric vehicles. Recharge after each use and avoid leaving it discharged for days. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 20.70 kg and M10M terminals.
Size, terminals and hold-down of the Fullriver HC110
It has external dimensions of 330 × 173 × 237 mm and weighs 20.70 kg. It uses M10M terminals, the system that anchors and connects it in the vehicle. Checking the three dimensions and the terminal position before buying avoids the most common mistake when replacing a battery.
The Fullriver HC110: HC range and AGM technology
Within the Fullriver catalogue, the HC series groups the references designed for this use. The HC110 is the 110 Ah model of that family, with the same performance as its siblings in other sizes.
AGM means the acid is held in a glass mat instead of floating free. That is why the battery can be installed in the cabin without gases, survives more cycles and recovers its charge quickly.
Why choose Fullriver batteries
With its own plants and a catalogue focused on high-performance AGM, Fullriver is a familiar brand in power wheelchairs, boats and photovoltaic systems that need thousands of cycles. We guarantee that every Fullriver arrives new, charged and with the manufacturer's full warranty.
Warranty and coverage
The Fullriver HC110 comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
How to make it last longer
Charge with a charger that has an AGM mode: it limits the voltage and protects the glass-fibre separators. Recharge the wheelchair or scooter after each use and do not leave it discharged for days: lead sulphates and loses capacity.
When you get it and how to return it
Order before 6:00 pm with stock available and it leaves today: mainland Spain and Portugal receive it in 24-48 working hours, the islands and the rest of the EU in 3 to 5 days. You have 14 days to return it if it has not been installed, with free collection on the mainland, and shipment tracking by email.
BCOM-FULLRIVER-HC110
Data sheet
- Brand
- FULLRIVER
- Reference
- HC110
- Model
- FULLRIVER HC
- Voltage (V)
- 12
- Length
- 330.00 mm
- Width
- 173.00 mm
- Height
- 237.00 mm
- Weight
- 20.70 Kgs
- Technology
- AGM
- Terminal type
- M10M
- Cold cranking amps (EN)
- 1100
- Capacity (C20)
- 110Ah (c20)
Specific References
- MPN
- HC110
4,73/5
Verified purchasesLatest verified reviews
★★★★★Jose Manuel Vicente
14/06/2026Me indicaron cómo instalar la batería
No tenía ni idea de cómo instalar la batería en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
★★★★★Jose Carlos Gallardo
24/01/2026Todo perfecto
Me ayudaron con la instalación de mi batería
★★★★★Jaime PeÑa
24/12/2025Muy buena ayuda con la instalación
Si tienes dudas con la instalación puedes llamar y te asesoran.
★★★★★Andres Moya
23/12/2025Me llegó al día siguiente
Hice el pedido de la batería un martes a las 7 y me llegó el miércoles a las 3
★★★★★Ignacio Herrera
28/09/2025Me ayudaron a poner la batería
No tenía ni idea de cómo instalar la bateria en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
Is the HC110 model AGM? What does this technology offer?
Yes. The HC110 from Fullriver uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I change this battery step by step?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Fullriver HC110 is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the measurements of the HC110 model?
Dimensions (length × width × height) are 330×173×237 mm — also written as 330x173x237 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which batteries are equivalent to the Fullriver HC110?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.