Fullriver HC14A · Wheelchair battery 12V 14Ah 200A AGM
Specifications
| Brand | FULLRIVER |
|---|---|
| Part number | HC14A |
| Voltage (V) | 12 |
| Capacity (C20) | 14Ah (c20) |
| Technology | AGM |
| Length | 155.00 mm |
| Width | 99.10 mm |
| Height | 157.00 mm |
| Weight | 30.00 Kgs |
€141.30
VAT included
4,66/5★★★★★13 reviewsVerified purchases
- ★★★★★Angel Arias:
No tenía ni idea de cómo instalar la batería en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
- ★★★★Ricardo Vargas:
Hice el pedido de la batería un martes a las 7 y me llegó el miércoles a las 3
- ★★★★Agustin Ruiz:
Me ayudaron con la instalación de mi batería
Fullriver HC14A 12V 14Ah 200A is a sealed AGM/GEL battery for daily mobility use: maintenance-free, no risk of spills, and thousands of useful cycles well beyond a starter battery.
Why this wheelchair battery?
- Daily cycling without wearhandles deep discharges without losing capacity
- Sealed AGM/GELno maintenance, no risk of spills
- Thousands of useful cyclesover its full lifetime
Voltage
12 V
Capacity
14 Ah
Cold cranking
200 A
Dimensions
155×99×157 mm
Technology
AGM
Weight
30 kg
Model
FULLRIVER HC
Mobility battery Fullriver HC14A HC 14Ah 200A 12V
12VVoltage
14AhCapacity
200ACold cranking
30kgWeight
The Fullriver HC14A with AGM technology delivers 14 Ah at 12 V with the cycle life that power wheelchairs, mobility scooters and light electric vehicles demand. It measures 155 × 99 × 157 mm, the format sought by anyone replacing a 14 Ah battery in power wheelchairs and mobility scooters.
- Standard replacement format for wheelchairs and scooters.
- Thousands of useful cycles over its lifetime.
- Designed to be discharged and recharged daily without losing capacity.
- AGM technology: absorbed electrolyte, no spills, can be mounted at an angle.
What the Fullriver HC14A is for
The Fullriver HC14A is the usual replacement in power wheelchairs, mobility scooters and light electric vehicles. Recharge after each use and avoid leaving it discharged for days. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 30 kg and M6 terminals.
Will it fit your current battery tray?
It has external dimensions of 155 × 99 × 157 mm and weighs 30 kg. It uses M6 terminals, the system that anchors and connects it in the vehicle. Checking the three dimensions and the terminal position before buying avoids the most common mistake when replacing a battery.
The Fullriver HC14A: HC range and AGM technology
The HC14A is part of the Fullriver HC range. Choosing the right reference within the series comes down to capacity, dimensions and terminals: technology and quality are common to the whole family.
AGM (Absorbent Glass Mat) technology seals the electrolyte in glass microfibre. The result is a maintenance-free battery that is highly vibration-resistant and able to withstand deep discharges that would ruin a classic lead-acid battery.
Fullriver: the maker behind the HC14A
Fullriver specialises in deep-cycle AGM batteries for mobility, marine, solar and traction. Its DC and HC series are known for their tolerance to deep discharge and long cycle life. We guarantee that every Fullriver arrives new, charged and with the manufacturer's full warranty.
Warranty and coverage
The Fullriver HC14A comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
Care and maintenance
Recharge the wheelchair or scooter after each use and do not leave it discharged for days: lead sulphates and loses capacity. Charge with a charger that has an AGM mode: it limits the voltage and protects the glass-fibre separators.
Shipping, delivery and returns
Order before 6:00 pm with stock available and it leaves today: mainland Spain and Portugal receive it in 24-48 working hours, the islands and the rest of the EU in 3 to 5 days. You have 14 days to return it if it has not been installed, with free collection on the mainland, and shipment tracking by email.
BCOM-FULLRIVER-HC14A
Data sheet
- Brand
- FULLRIVER
- Reference
- HC14A
- Model
- FULLRIVER HC
- Voltage (V)
- 12
- Length
- 155.00 mm
- Width
- 99.10 mm
- Height
- 157.00 mm
- Weight
- 30.00 Kgs
- Technology
- AGM
- Terminal type
- M6
- Cold cranking amps (EN)
- 200
- Capacity (C20)
- 14Ah (c20)
Specific References
- MPN
- HC14A
4,66/5
Verified purchasesLatest verified reviews
★★★★★Angel Arias
14/07/2026Gracias
No tenía ni idea de cómo instalar la batería en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
★★★★★Ricardo Vargas
28/01/2026Recibí la batería en 1 día
Hice el pedido de la batería un martes a las 7 y me llegó el miércoles a las 3
★★★★★Agustin Ruiz
26/01/2026Oye, un 10
Me ayudaron con la instalación de mi batería
★★★★★Tomas Soto
16/01/2026No sabía que el asesoramiento era gratis, de 10
Si tienes dudas con la instalación puedes llamar y te asesoran.
★★★★★Jose Ignacio Hidalgo
07/11/2025Muy útil su ayuda
No tenía ni idea de cómo instalar la bateria en mi coche y me ayudaron a instalarla correctamente. Muchas gracias
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
Is the Fullriver HC14A an AGM battery and what are the benefits of AGM?
Yes. The HC14A from Fullriver uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How is the Fullriver HC14A battery installed in the vehicle?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Fullriver HC14A is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What size is this battery?
Dimensions (length × width × height) are 155×99×157 mm — also written as 155x99x157 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which batteries are equivalent to the Fullriver HC14A?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.