Fulbat 6N11A-1B/3A GEL · Motorcycle battery 6V 11.6Ah 90A GEL
Specifications
| Brand | FULBAT |
|---|---|
| Part number | 6N11A-1B/3A GEL |
| Voltage (V) | 6V |
| Capacity (C20) | 11.60Ah |
| Capacity (C10) | 11Ah (c10) |
| Technology | GEL |
| Length | 121mm |
| Width | 58mm |
| Height | 130mm |
€38.70
VAT included
Fulbat 6N11A-1B/3A GEL 6V 11,6Ah 90A is a motorcycle starter battery with standard JIS code (the one on your bike's original label). Ready to use, sealed and vibration-resistant. Fits any model that takes the same JIS reference — the code your mechanic recognises at a glance.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season
Voltage
6 V
Capacity
11,6 Ah
Cold cranking
90 A
Dimensions
121×58×130 mm
Technology
GEL
Polarity
Positive on the right
Motorcycle battery Fulbat 6N11A-1B/3A 11.6Ah 90A 6V
6VVoltage
11.6AhCapacity
90ACold cranking
The Fulbat 6N11A-1B/3A motorcycle battery is rated at 6 V, 11.6 Ah and 90 A of cold cranking current (EN), and is designed for motorcycles, scooters, quads and personal watercraft. It replaces the original battery without adaptation in motorcycles with a 121 × 58 × 130 mm format: same 11.6 Ah capacity and the positive terminal on the right.
- Resistant to the vibration typical of two wheels.
- Energetic cranking for high-compression engines.
- GEL technology: gelled electrolyte, fully sealed and maintenance-free.
- Same JIS code as the original battery: fits first time.
What the Fulbat 6N11A-1B/3A is for
With 11.6 Ah, the Fulbat 6N11A-1B/3A covers the starting of motorcycles, scooters, quads and personal watercraft. The JIS code on your current battery label is the safest way to confirm equivalence.
Size, terminals and hold-down of the Fulbat 6N11A-1B/3A
It has external dimensions of 121 × 58 × 130 mm. The positive terminal on the right decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
Technology inside the Fulbat 6N11A-1B/3A
The 6N11A-1B/3A is one of the Fulbat references for this type of use; it shares the same manufacturing and quality-control criteria as the rest of the brand's catalogue.
GEL technology fixes the acid in a solid gel. That removes maintenance and leaks and gives very long cycle life, in exchange for slightly slower recharging and lower peak current than an AGM.
Why choose Fulbat batteries
Fulbat has manufactured in France since 1978 and specialises in motorcycles and light vehicles. Its catalogue is short and clear, covers almost the whole fleet and works only with sealed, leak-free batteries. We guarantee that every Fulbat arrives new, charged and with the manufacturer's full warranty.
Warranty and coverage
The Fulbat 6N11A-1B/3A comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
Care and maintenance
Check the resting voltage before the season (above 12.6 V on a charged battery) and make sure the terminals are clean and tight. Avoid repeated cranking attempts on a cold bike for long: if it does not start on the third try, let the battery rest for a minute.
When you get it and how to return it
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-FULBAT-6N11A-1B/3A GEL
Data sheet
- Brand
- FULBAT
- Model
- FULBAT Motorcycle GEL
- Voltage (V)
- 6V
- Length
- 121mm
- Width
- 58mm
- Height
- 130mm
- Technology
- GEL
- Terminal layout
- Positive right
- Cold cranking amps (EN)
- 90A
- Capacity (C20)
- 11.60Ah
- Capacity (C10)
- 11Ah (c10)
Specific References
- MPN
- 6N11A-1B/3A GEL
Comparison: Fulbat 6N11A-1B/3A GEL vs equivalents
The Fulbat 6N11A-1B/3A GEL is interchangeable with these equivalent references: 012014008 (Varta).
| Product | Specifications | Technology | Price |
|---|---|---|---|
Fulbat
6N11A-1B/3A GEL
This battery
|
€38.70 | ||
Varta
012014008
|
6V 11Ah 80A | Lead-acid | €62.30 |
Equivalences verified by our technical team: same dimensions, polarity, capacity and CCA. Official manufacturer warranty on every option.
Recommended accessories
How to change the battery
Guide to replace your motorcycle battery in 10-15 minutes. Motorcycle batteries are light (2-5 kg) and usually need an 8 mm wrench.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
On motorcycles it is usually under the seat, in the rear cowl or behind a side panel. Check the manual — access varies a lot between models.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Loosen the hold-down clamp or the straps that secure it. Lift the battery carefully — typical weight 2-5 kg. Check the terminals are not corroded before fitting the new one.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify the engine starts
Close the bonnet. Start the engine to confirm everything works. On cars with Start-Stop or a BMS, you may need to register the battery via OBD so the alternator applies the correct charging profile.
Frequently asked questions
How do I fit the 6N11A-1B/3A GEL model in my motorcycle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the 6N11A-1B/3A GEL model?
Expected lifespan of the Fulbat 6N11A-1B/3A GEL is 4 to 7 years in regular use (depends on technology and climate). In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What size is this battery?
Dimensions (length × width × height) are 121×58×130 mm — also written as 121x58x130 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Is the 6N11A-1B/3A GEL valid for my vehicle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The 6N11A-1B/3A GEL typically fits a wide range of European vehicles thanks to its standard DIN case format.
Which batteries are equivalent to the Fulbat 6N11A-1B/3A GEL?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.