Fulbat FHD32HL-BS GEL · Motorcycle battery 12V 33.6Ah 445A GEL
Specifications
| Brand | FULBAT |
|---|---|
| Part number | FHD32HL-BS GEL |
| Voltage (V) | 12V |
| Capacity (C20) | 33.60Ah |
| Capacity (C10) | 32Ah (c10) |
| Cold cranking amps (EN) | 445A |
| Technology | GEL |
| Length | 165mm |
| Width | 130mm |
Fulbat FHD32HL-BS GEL 12V 33,6Ah 445A is a motorcycle starter battery with standard JIS code (the one on your bike's original label). Ready to use, sealed and vibration-resistant. Fits any model that takes the same JIS reference — the code your mechanic recognises at a glance.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season

Motorcycle battery Fulbat FHD32HL-BS 33.6Ah 445A 12V
The Fulbat FHD32HL-BS motorcycle battery is rated at 12 V, 33.6 Ah and 445 A of cold cranking current (EN), and is designed for motorcycles, scooters, quads and personal watercraft. It measures 165 × 130 × 175 mm and the positive terminal on the right, the format sought by anyone replacing a 33.6 Ah battery in motorcycles.
- Energetic cranking for high-compression engines.
- Resistant to the vibration typical of two wheels.
- Same JIS code as the original battery: fits first time.
- GEL technology: gelled electrolyte, fully sealed and maintenance-free.
Dimensions, polarity and mounting
The Fulbat FHD32HL-BS is made in the 165 × 130 × 175 mm format. The positive terminal on the right decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. For a direct replacement, the current battery tray must accept these dimensions and the same terminal layout; otherwise adapters will be needed or the hold-down will change.
What the Fulbat FHD32HL-BS is for
Designed for motorcycles, scooters, quads and personal watercraft, the Fulbat FHD32HL-BS replaces the original battery of bikes that use this code or format. Check the position of the positive terminal before ordering.
Technology inside the Fulbat FHD32HL-BS
Fulbat builds the FHD32HL-BS to the same standards as the rest of its catalogue; what changes between references is capacity, format and terminal position.
In a GEL battery the electrolyte is gelled with silica: it is fully sealed, cannot spill and tolerates deep discharge very well. It is the preferred technology in electric mobility, marine service and heavy-cycling applications.
Fulbat: the maker behind the FHD32HL-BS
French brand Fulbat is a European reference in motorcycle, garden and leisure batteries: compact ranges, clear JIS codes and a consistent quality that workshops know well. All the Fulbat batteries in our catalogue are genuine product, recently manufactured and covered by the manufacturer's warranty.
Manufacturer's warranty
The Fulbat FHD32HL-BS comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
Usage and maintenance tips
Avoid repeated cranking attempts on a cold bike for long: if it does not start on the third try, let the battery rest for a minute. GEL batteries need lower charging voltages: always use a charger with a GEL mode so as not to damage the electrolyte.
When you get it and how to return it
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
Data sheet
-
BrandFULBAT
-
ModelFULBAT Motorcycle GEL
-
Voltage (V)12V
-
Length165mm
-
Width130mm
-
Height175mm
-
TechnologyGEL
-
Terminal layoutPositive right
-
Cold cranking amps (EN)445A
-
Capacity (C20)33.60Ah
-
Capacity (C10)32Ah (c10)
Specific References
-
MPNFHD32HL-BS GEL
Recommended accessories
Frequently asked questions
How is the Fulbat FHD32HL-BS GEL battery installed in the vehicle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on our blog. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Fulbat FHD32HL-BS GEL is 4 to 7 years in regular use (depends on technology and climate). In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the measurements of the FHD32HL-BS GEL model?
Dimensions (length × width × height) are 165×130×175 mm — also written as 165x130x175 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Will the Fulbat FHD32HL-BS GEL battery fit my motorcycle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The FHD32HL-BS GEL typically fits a wide range of European vehicles thanks to its standard DIN case format.
What are the equivalents of the FHD32HL-BS GEL model?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.