Long HTP200-12N · Stationary UPS battery 12V 200Ah AGM
Specifications
| Brand | LONG |
|---|---|
| Part number | HTP200-12N |
| Voltage (V) | 12 |
| Capacity (C20) | 200Ah (c20) |
| Capacity (C5) | 170Ah (c5) |
| Technology | AGM |
| Length | 522.00 cm |
| Width | 238.00 cm |
| Height | 224.00 cm |
This product is priced on demand to offer you the best available price at all times.
Please contact us to request a quote and we will inform you about availability and the best price on the entire website, as well as the delivery time.
Thank you
Long HTP200-12N 12V 200Ah is a stationary battery for backup power systems: UPS, alarms, telecom and emergency lighting. Long float-life under permanent charge and instant response to mains outages with no noticeable voltage drop.
Why this stationary battery?
- Instant responsewhen the mains drop, no voltage dip
- Long life under 24/7 chargeoptimised for permanent service
- Compatible with your systemexisting UPS units and alarm control panels
Voltage
12 V
Capacity
200 Ah
Dimensions
522×238×224 mm
Technology
AGM
Weight
73,2 kg
Model
HTP Series
Free quote, no obligation
Request a quote for your Stationary UPS battery Long HTP200-12N 12V 200Ah AGM
- Reply in under 24 working hours
- Best price guaranteed
Stationary battery Long HTP200-12N HTP Series 200Ah 12V
12VVoltage
200AhCapacity
73.20kgWeight
The 12 V, 200 Ah Long HTP200-12N stationary battery from the HTP Series range with AGM technology is designed for UPS, alarms, telecoms and emergency lighting. Its 522 × 238 × 224 mm make it the exact replacement for the 200 Ah battery fitted as standard to many UPS, alarm and emergency systems.
- Standard format for UPS and emergency systems.
- Low self-discharge and high reliability.
- Instant response to mains failures.
- AGM: faster recharging and better cycle resistance than a conventional battery.
What the Long HTP200-12N is for
With 200 Ah, the Long HTP200-12N gives your UPS or emergency system the autonomy it needs. Replace all the batteries in the set at once. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 73.20 kg.
Will it fit your current battery tray?
The Long HTP200-12N is made in the 522 × 238 × 224 mm format and weighs 73.20 kg. Checking the three dimensions and the terminal position before buying avoids the most common mistake when replacing a battery.
What Long does differently
Long batteries combine large-scale production with ISO quality standards and a batch-to-batch consistency that has made them the de-facto standard in backup systems and electric mobility. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
The Long HTP200-12N: HTP Series range and AGM technology
The HTP Series is the Long range the HTP200-12N belongs to: it shares the same construction and quality criteria with the rest of the series, and varies in capacity and format to suit each vehicle.
AGM (Absorbent Glass Mat) technology seals the electrolyte in glass microfibre. The result is a maintenance-free battery that is highly vibration-resistant and able to withstand deep discharges that would ruin a classic lead-acid battery.
How to make it last longer
Charge with a charger that has an AGM mode: it limits the voltage and protects the glass-fibre separators. Check the float voltage of the UPS or charger: a voltage that is too high shortens the life of a sealed battery.
Manufacturer's warranty
The Long HTP200-12N comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
Shipping, delivery and returns
Order before 6:00 pm with stock available and it leaves today: mainland Spain and Portugal receive it in 24-48 working hours, the islands and the rest of the EU in 3 to 5 days. You have 14 days to return it if it has not been installed, with free collection on the mainland, and shipment tracking by email.
BCOM-LONG-HTP200-12N
Data sheet
- Brand
- LONG
- Reference
- HTP200-12N
- Model
- HTP Series
- Voltage (V)
- 12
- Length
- 522.00 cm
- Width
- 238.00 cm
- Height
- 224.00 cm
- Weight
- 73.20 Kgs
- Technology
- AGM
- Capacity (C20)
- 200Ah (c20)
- Capacity (C5)
- 170Ah (c5)
Specific References
- MPN
- HTP200-12N
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
Is the HTP200-12N model AGM? What does this technology offer?
Yes. The HTP200-12N from Long uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I fit the HTP200-12N model in my device?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the HTP200-12N model?
Expected lifespan of the Long HTP200-12N is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Long HTP200-12N battery?
Dimensions (length × width × height) are 522×238×224 mm — also written as 522x238x224 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which interchangeable batteries are there for this one?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.