Long WP7-12(28W)T · Stationary UPS battery 12V 7Ah AGM
Specifications
| Brand | LONG |
|---|---|
| Part number | WP7-12(28W)T |
| Voltage (V) | 12 |
| Capacity (C20) | 7Ah (c20) |
| Technology | AGM |
| Length | 151.00 cm |
| Width | 65.00 cm |
| Height | 106.00 cm |
| Weight | 2.19 Kgs |
This product is priced on demand to offer you the best available price at all times.
Please contact us to request a quote and we will inform you about availability and the best price on the entire website, as well as the delivery time.
Thank you
Long WP7-12(28W)T 12V 7Ah is a stationary battery for backup power systems: UPS, alarms, telecom and emergency lighting. Long float-life under permanent charge and instant response to mains outages with no noticeable voltage drop.
Why this stationary battery?
- Instant responsewhen the mains drop, no voltage dip
- Long life under 24/7 chargeoptimised for permanent service
- Compatible with your systemexisting UPS units and alarm control panels
Voltage
12 V
Capacity
7 Ah
Dimensions
151×65×106 mm
Technology
AGM
Weight
2,19 kg
Model
WP WATT Series
Free quote, no obligation
Request a quote for your Stationary UPS battery Long WP7-12(28W)T 12V 7Ah AGM
- Reply in under 24 working hours
- Best price guaranteed
Stationary battery Long WP7-12(28W)T WP WATT Series 7Ah 12V
12VVoltage
7AhCapacity
2.19kgWeight
Designed for UPS, alarms, telecoms and emergency lighting, the Long WP7-12(28W)T from the WP WATT Series range offers 7 Ah with AGM technology on permanent float charge. Its 151 × 65 × 106 mm make it the exact replacement for the 7 Ah battery fitted as standard to many UPS, alarm and emergency systems.
- Instant response to mains failures.
- AGM: faster recharging and better cycle resistance than a conventional battery.
- Standard format for UPS and emergency systems.
- Low self-discharge and high reliability.
What the Long WP7-12(28W)T is for
Designed for UPS, alarms, telecoms and emergency lighting, the Long WP7-12(28W)T is sealed, gas-free and suitable for technical cabinets and offices. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 2.19 kg.
Size, terminals and hold-down of the Long WP7-12(28W)T
The Long WP7-12(28W)T is made in the 151 × 65 × 106 mm format and weighs 2.19 kg. For a direct replacement, the current battery tray must accept these dimensions and the same terminal layout; otherwise adapters will be needed or the hold-down will change.
The Long WP7-12(28W)T: WP WATT Series range and AGM technology
Within the Long catalogue, the WP WATT Series series groups the references designed for this use. The WP7-12(28W)T is the 7 Ah model of that family, with the same performance as its siblings in other sizes.
In an AGM battery the electrolyte is absorbed in glass-fibre separators: there is no free liquid, it cannot spill and it can be mounted at an angle. That construction lowers internal resistance, speeds up recharging and multiplies cycle life compared with a conventional battery.
Why choose Long batteries
Long batteries combine large-scale production with ISO quality standards and a batch-to-batch consistency that has made them the de-facto standard in backup systems and electric mobility. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
Manufacturer's warranty
The Long WP7-12(28W)T comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
How to make it last longer
Check the float voltage of the UPS or charger: a voltage that is too high shortens the life of a sealed battery. Replace all the batteries in the set at once and avoid environments continuously above 25 °C.
Delivery times and returns
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-LONG-WP7-12(28W)T
Data sheet
- Brand
- LONG
- Reference
- WP7-12(28W)T
- Model
- WP WATT Series
- Voltage (V)
- 12
- Length
- 151.00 cm
- Width
- 65.00 cm
- Height
- 106.00 cm
- Weight
- 2.19 Kgs
- Technology
- AGM
- Capacity (C20)
- 7Ah (c20)
- Energy (Wh)
- 28
Specific References
- MPN
- WP7-12(28W)T
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
Is the WP7-12(28W)T model AGM? What does this technology offer?
Yes. The WP7-12(28W)T from Long uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I fit the WP7-12(28W)T model in my device?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the WP7-12(28W)T model?
Expected lifespan of the Long WP7-12(28W)T is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Long WP7-12(28W)T battery?
Dimensions (length × width × height) are 151×65×106 mm — also written as 151x65x106 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which batteries are equivalent to the Long WP7-12(28W)T?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.