Motobatt MTX7L · Motorcycle battery 12V 7Ah 105A GEL
Specifications
| Brand | MOTOBATT |
|---|---|
| Part number | MTX7L |
| Voltage (V) | 12 |
| Capacity (C20) | 7Ah (c20) |
| Capacity (C10) | 7Ah (c10) |
| Technology | GEL |
| Length | 113.00 mm |
| Width | 70.00 mm |
| Height | 129.00 mm |
€149.40
VAT included
4,76/5★★★★★25 reviewsVerified purchases
- ★★★★★David Alonso:
Excelente atención telefònico, recomiendo llamar a su número antes de comprar en otra web
- ★★★★Pedro Ruiz:
Resolvieron todas mis dudas
- ★★★★Jose Ramon Cruz:
Recomiendo la web por su trato al momento de elegir
Motobatt MTX7L 12V 7Ah 105A is a motorcycle starter battery with standard JIS code (the one on your bike's original label). Ready to use, sealed and vibration-resistant. Fits any model that takes the same JIS reference — the code your mechanic recognises at a glance.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season
JIS code
YTX7LBS
Voltage
12 V
Capacity
7 Ah
Cold cranking
105 A
Dimensions
113×70×129 mm
Technology
GEL
Weight
2,62 kg
Model
MOTOBATT SUPER GEL
Mfr. reference
MTX7L
Motorcycle battery Motobatt YTX7LBS Super GEL 7Ah 105A 12V
JIS codeYTX7LBS
12VVoltage
7AhCapacity
105ACold cranking
2.62kgWeight
The Motobatt YTX7LBS from the Super GEL range is a motorcycle battery with 7 Ah and 105 A of cold cranking current (EN), designed for motorcycles, scooters, quads and personal watercraft. Measuring 113 × 70 × 129 mm, it is the direct replacement for motorcycles fitted from the factory with a 7 Ah battery of this format.
- GEL: excellent resistance to deep discharge and long cycle life.
- Sealed and ready to fit, no acid handling.
- Holds its charge through winter storage.
- Compact and lightweight format.
Dimensions, polarity and mounting
The Motobatt YTX7LBS is made in the 113 × 70 × 129 mm format and weighs 2.62 kg. Checking the three dimensions and the terminal position before buying avoids the most common mistake when replacing a battery.
What the Motobatt YTX7LBS is for
The Motobatt YTX7LBS is a common replacement in motorcycles, scooters, quads and personal watercraft. If your bike spends the winter standing, a trickle charger stops it reaching spring flat. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 2.62 kg.
The Motobatt YTX7LBS: Super GEL range and GEL technology
Within the Motobatt catalogue, the Super GEL series groups the references designed for this use. The YTX7LBS is the 7 Ah model of that family, with the same performance as its siblings in other sizes.
A GEL battery is the choice when cycle resistance and safety matter most: no gases, no liquid and thousands of partial discharges in its lifetime.
Why choose Motobatt batteries
Motobatt is the motorcycle battery specialist with Quadflex technology: four terminals that let you connect the battery in any position and a sealed AGM construction ready to fit. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
Manufacturer's warranty
The Motobatt YTX7LBS comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
Care and maintenance
GEL batteries need lower charging voltages: always use a charger with a GEL mode so as not to damage the electrolyte. Check the resting voltage before the season (above 12.6 V on a charged battery) and make sure the terminals are clean and tight.
Shipping, delivery and returns
Same-day dispatch from our warehouse for in-stock orders placed before 6:00 pm: 24-48 working hours in mainland Spain and Portugal, 3 to 5 days in the islands and the rest of Europe. Returns are accepted for 14 days if the battery has not been used (free collection on the Iberian mainland). You will receive tracking by email.
BCOM-MOTOBATT-MTX7L
Data sheet
- Brand
- MOTOBATT
- Reference
- MTX7L
- Model
- MOTOBATT SUPER GEL
- Voltage (V)
- 12
- Length
- 113.00 mm
- Width
- 70.00 mm
- Height
- 129.00 mm
- Weight
- 2.62 Kgs
- Technology
- GEL
- JIS
- YTX7LBS
- Cold cranking amps (EN)
- 105A
- Capacity (C20)
- 7Ah (c20)
- Capacity (C10)
- 7Ah (c10)
Specific References
- MPN
- MTX7L
4,76/5
Verified purchasesLatest verified reviews
★★★★★David Alonso
16/06/2026Buena atención
Excelente atención telefònico, recomiendo llamar a su número antes de comprar en otra web
★★★★★Pedro Ruiz
09/02/2026Gran atención
Resolvieron todas mis dudas
★★★★★Jose Ramon Cruz
08/01/2026Buen servicio
Recomiendo la web por su trato al momento de elegir
★★★★★Juan Jose Rodriguez
04/01/2026De lo mejor
Recomiendo esta web, excelente servicio
Recommended accessories
How to change the battery
Guide to replace your motorcycle battery in 10-15 minutes. Motorcycle batteries are light (2-5 kg) and usually need an 8 mm wrench.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
On motorcycles it is usually under the seat, in the rear cowl or behind a side panel. Check the manual — access varies a lot between models.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Loosen the hold-down clamp or the straps that secure it. Lift the battery carefully — typical weight 2-5 kg. Check the terminals are not corroded before fitting the new one.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify the engine starts
Close the bonnet. Start the engine to confirm everything works. On cars with Start-Stop or a BMS, you may need to register the battery via OBD so the alternator applies the correct charging profile.
Frequently asked questions
Is the YTX7LBS model a gel battery? Where is it used?
Yes, this model is a GEL battery: sealed lead-acid where the electrolyte is in gel form. It tolerates deep discharges very well and is ideal for cyclic use (solar, motorhomes, electric wheelchairs, motorcycles). Requires a GEL-specific smart charger — max charge voltage ~14.1 V (vs 14.4-14.7 V for AGM). Lifespan 6-10 years.
How do I fit the YTX7LBS model in my motorcycle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How many years does this battery last?
Expected lifespan of the Motobatt YTX7LBS is 6 to 10 years in cyclic use (marine, caravan, solar) with controlled discharges. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Motobatt YTX7LBS battery?
Dimensions (length × width × height) are 113×70×129 mm — also written as 113x70x129 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Is the YTX7LBS valid for my vehicle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The YTX7LBS typically fits a wide range of European vehicles thanks to its standard DIN case format.
Which batteries are equivalent to the Motobatt YTX7LBS?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.