Fulbat FLTK01 · Motorcycle battery 2Ah 140A LiFePO4
Specifications
| Brand | FULBAT |
|---|---|
| Part number | FLTK01 |
| Capacity (C10) | 2Ah (c10) |
| Cold cranking amps (EN) | 140A |
| Technology | LiFePO4 |
| Length | 86mm |
| Width | 48mm |
| Height | 90mm |
| Weight | 0.36 Kg |
Fulbat FLTK01 2Ah 140A is a quality battery with official manufacturer warranty, confirmed stock and 24-48 h delivery across the peninsula.
Why this battery?
- Tested and certifiedto European EN standards for maximum reliability
- Sealed and maintenance-freeready to use out of the box
- Long working lifeoptimised for its real-world use case

Lithium motorcycle battery Fulbat FLTK01 2Ah 140A
The Fulbat FLTK01 is a lithium battery rated at V and 140 A of cold cranking current (EN) for motorcycles and quads looking to save weight and gain cranking power. It replaces the original battery without adaptation in motorcycles with a 86 × 48 × 90 mm format: same 2 Ah capacity and the positive terminal on the right.
- LiFePO4 lithium: minimal weight and almost zero self-discharge.
- Up to 70% less weight than an equivalent lead-acid battery.
- Minimal self-discharge: ready to use all season.
- Thousands of cycles of service life.
What the Fulbat FLTK01 is for
The Fulbat FLTK01 cranks hard even after weeks standing thanks to its minimal self-discharge. Always use a LiFePO4-compatible charger. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 0.36 kg.
Will it fit your current battery tray?
In terms of format, the Fulbat FLTK01 measures 86 × 48 × 90 mm (length × width × height) and weighs 0.36 kg. The positive terminal on the right decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
Technology inside the Fulbat FLTK01
Fulbat builds the FLTK01 to the same standards as the rest of its catalogue; what changes between references is capacity, format and terminal position.
A LiFePO4 battery starts with the same nominal voltage as a lead-acid one but with far less weight and a service life several times longer. It requires a lithium-compatible charger.
Why choose Fulbat batteries
Fulbat has manufactured in France since 1978 and specialises in motorcycles and light vehicles. Its catalogue is short and clear, covers almost the whole fleet and works only with sealed, leak-free batteries. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
Official warranty
The Fulbat FLTK01 comes with the manufacturer's official warranty. Always charge with a LiFePO4-compatible charger: a lead-acid charger with a desulphation phase can damage it and void the warranty.
Care and maintenance
Store the battery at 50-70% charge if it will be unused for months. Check that the bike's regulator does not exceed 14.6 V; if the vehicle stands for long periods, an occasional maintenance charge is enough.
When you get it and how to return it
Order before 6:00 pm with stock available and it leaves today: mainland Spain and Portugal receive it in 24-48 working hours, the islands and the rest of the EU in 3 to 5 days. You have 14 days to return it if it has not been installed, with free collection on the mainland, and shipment tracking by email.
Recommended accessories
Frequently asked questions
How do I fit the FLTK01 model in my car?
In most cars it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on our blog. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On cars with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How long does the Fulbat FLTK01 battery last?
Expected lifespan of the Fulbat FLTK01 is 4 to 7 years in regular use (depends on technology and climate). In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the measurements of the FLTK01 model?
Dimensions (length × width × height) are 86×48×90 mm — also written as 86x48x90 mm — following the European DIN standard. Always measure the space in your car before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which interchangeable batteries are there for this one?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop cars. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.