Fulbat FTX7A-BS GEL · Motorcycle battery 12V 6.3Ah 90A GEL
Specifications
| Brand | FULBAT |
|---|---|
| Part number | FTX7A-BS GEL |
| Voltage (V) | 12V |
| Capacity (C20) | 6.30Ah |
| Capacity (C10) | 6Ah (c10) |
| Technology | GEL |
| Length | 150mm |
| Width | 87mm |
| Height | 93mm |
€49.95
VAT included
Fulbat FTX7A-BS GEL 12V 6,3Ah 90A is a sealed motorcycle battery ready to fit, with the JIS reference your mechanic recognises at a glance. Vibration-resistant, keeps voltage during the winter off-season and cranks first time when you take it out for a ride.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season
Voltage
12 V
Capacity
6,3 Ah
Cold cranking
90 A
Dimensions
150×87×93 mm
Technology
GEL
Polarity
Positive on the left
Motorcycle battery Fulbat FTX7A-BS 6.3Ah 90A 12V
12VVoltage
6.3AhCapacity
90ACold cranking
With 6.3 Ah at 12 V and 90 A of cold cranking current (EN), the Fulbat FTX7A-BS with GEL technology replaces the original battery of motorcycles, scooters, quads and personal watercraft. Measuring 150 × 87 × 93 mm and the positive terminal on the left, it is the direct replacement for motorcycles fitted from the factory with a 6.3 Ah battery of this format.
- Holds its charge through winter storage.
- Compact and lightweight format.
- GEL: excellent resistance to deep discharge and long cycle life.
- Sealed and ready to fit, no acid handling.
What the Fulbat FTX7A-BS is for
Designed for motorcycles, scooters, quads and personal watercraft, the Fulbat FTX7A-BS replaces the original battery of bikes that use this code or format. Check the position of the positive terminal before ordering.
Technology inside the Fulbat FTX7A-BS
The FTX7A-BS is one of the Fulbat references for this type of use; it shares the same manufacturing and quality-control criteria as the rest of the brand's catalogue.
A GEL battery is the choice when cycle resistance and safety matter most: no gases, no liquid and thousands of partial discharges in its lifetime.
Size, terminals and hold-down of the Fulbat FTX7A-BS
The Fulbat FTX7A-BS is made in the 150 × 87 × 93 mm format. The positive terminal on the left decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. Checking the three dimensions and the terminal position before buying avoids the most common mistake when replacing a battery.
Why choose Fulbat batteries
French brand Fulbat is a European reference in motorcycle, garden and leisure batteries: compact ranges, clear JIS codes and a consistent quality that workshops know well. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
How to make it last longer
If the bike spends the winter standing, connect a trickle charger: deep discharge through inactivity is the first cause of premature failure. Check the resting voltage before the season (above 12.6 V on a charged battery) and make sure the terminals are clean and tight.
Warranty and coverage
The Fulbat FTX7A-BS comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
Delivery times and returns
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-FULBAT-FTX7A-BS GEL
Data sheet
- Brand
- FULBAT
- Model
- FULBAT Motorcycle GEL
- Voltage (V)
- 12V
- Length
- 150mm
- Width
- 87mm
- Height
- 93mm
- Technology
- GEL
- Terminal layout
- Positive left
- Cold cranking amps (EN)
- 90A
- Capacity (C20)
- 6.30Ah
- Capacity (C10)
- 6Ah (c10)
Specific References
- MPN
- FTX7A-BS GEL
Recommended accessories
How to change the battery
Guide to replace your motorcycle battery in 10-15 minutes. Motorcycle batteries are light (2-5 kg) and usually need an 8 mm wrench.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
On motorcycles it is usually under the seat, in the rear cowl or behind a side panel. Check the manual — access varies a lot between models.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Loosen the hold-down clamp or the straps that secure it. Lift the battery carefully — typical weight 2-5 kg. Check the terminals are not corroded before fitting the new one.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify the engine starts
Close the bonnet. Start the engine to confirm everything works. On cars with Start-Stop or a BMS, you may need to register the battery via OBD so the alternator applies the correct charging profile.
Frequently asked questions
How is the Fulbat FTX7A-BS GEL battery installed in the vehicle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
What is the service life of the FTX7A-BS GEL model?
Expected lifespan of the Fulbat FTX7A-BS GEL is 4 to 7 years in regular use (depends on technology and climate). In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Fulbat FTX7A-BS GEL battery?
Dimensions (length × width × height) are 150×87×93 mm — also written as 150x87x93 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Does this battery fit my motorcycle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The FTX7A-BS GEL typically fits a wide range of European vehicles thanks to its standard DIN case format.
What are the equivalents of the FTX7A-BS GEL model?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.