Long WP10-6 · Stationary UPS battery 6V 10Ah AGM

Batería Long WP10-6 10Ah - 1
search
  • Batería Long WP10-6 10Ah - 1
  • Batería Long WP10-6 10Ah - 2

Specifications

BrandLONG
Part numberWP10-6
Voltage (V)6
Capacity (C20)10Ah (c20)
Capacity (C5)8.5Ah (c5)
TechnologyAGM
Length151.00 cm
Width50.00 cm
Height100.00 cm
See the full specifications →

This product is priced on demand to offer you the best available price at all times.

Please contact us to request a quote and we will inform you about availability and the best price on the entire website, as well as the delivery time.

Thank you

Long WP10-6 6V 10Ah is a stationary battery for backup power systems: UPS, alarms, telecom and emergency lighting. Long float-life under permanent charge and instant response to mains outages with no noticeable voltage drop.

Why this stationary battery?

  • Instant responsewhen the mains drop, no voltage dip
  • Long life under 24/7 chargeoptimised for permanent service
  • Compatible with your systemexisting UPS units and alarm control panels
Voltage
6 V
Capacity
10 Ah C20
Dimensions
151×50×100 mm
Technology
AGM
Weight
1,7 kg
Model
WP Series
Free quote, no obligation

Request a quote for your Stationary UPS battery Long WP10-6 6V 10Ah AGM

  • Reply in under 24 working hours
  • Best price guaranteed
Attach photo (optional)
Photo of the old battery or vehicle documentation · Max. 3 · 8 MB · images or PDF
Logo Long

Mobility battery Long WP10-6 WP Series 10Ah 6V

6VVoltage
10AhCapacity
1.70kgWeight

The Long WP10-6 with AGM technology delivers 10 Ah at 6 V with the cycle life that power wheelchairs, mobility scooters and light electric vehicles demand. Its 151 × 50 × 100 mm make it the exact replacement for the 10 Ah battery fitted as standard to many power wheelchairs and mobility scooters.

  • Approved for air and sea transport (VRLA).
  • No maintenance, no water top-ups.
  • Sealed AGM/GEL: safe indoors and in transport.
  • AGM: faster recharging and better cycle resistance than a conventional battery.

Will it fit your current battery tray?

The Long WP10-6 is made in the 151 × 50 × 100 mm format and weighs 1.70 kg. For a direct replacement, the current battery tray must accept these dimensions and the same terminal layout; otherwise adapters will be needed or the hold-down will change.

What the Long WP10-6 is for

The Long WP10-6 is designed for power wheelchairs, mobility scooters and light electric vehicles. Wheelchairs and scooters normally use two identical batteries in series: replace them together. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 1.70 kg.

The Long WP10-6: WP Series range and AGM technology

The WP Series is the Long range the WP10-6 belongs to: it shares the same construction and quality criteria with the rest of the series, and varies in capacity and format to suit each vehicle.

AGM (Absorbent Glass Mat) technology seals the electrolyte in glass microfibre. The result is a maintenance-free battery that is highly vibration-resistant and able to withstand deep discharges that would ruin a classic lead-acid battery.

Why choose Long batteries

Long batteries combine large-scale production with ISO quality standards and a batch-to-batch consistency that has made them the de-facto standard in backup systems and electric mobility. All the Long batteries in our catalogue are genuine product, recently manufactured and covered by the manufacturer's warranty.

Official warranty

The Long WP10-6 comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.

How to make it last longer

Recharge the wheelchair or scooter after each use and do not leave it discharged for days: lead sulphates and loses capacity. Use the original charger or one compatible with the battery technology (AGM/GEL) and always replace both batteries in the set together.

Delivery times and returns

Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.

BCOM-LONG-WP10-6

Data sheet

Brand
LONG
Reference
WP10-6
Model
WP Series
Voltage (V)
6
Length
151.00 cm
Width
50.00 cm
Height
100.00 cm
Weight
1.70 Kgs
Technology
AGM
Capacity (C20)
10Ah (c20)
Capacity (C5)
8.5Ah (c5)

Specific References

MPN
WP10-6

Recommended accessories — complement the Long WP10-6 with a charger or tester

How to change the battery

Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.

⏱ 10-15 min🛠 Tools: Screwdriver or small wrench (3-5 mm typical) · Protective gloves
  1. Step 1. Power off and unplug the device

    Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.

  2. Step 2. Locate the battery compartment

    Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.

  3. Step 3. Disconnect the negative (−) first

    With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.

  4. Step 4. Disconnect the positive (+) terminal

    Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.

  5. Step 5. Remove the old battery

    Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.

  6. Step 6. Fit the new battery

    Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.

  7. Step 7. Connect the positive (+) first

    On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.

  8. Step 8. Initial charge before first use

    Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.

Frequently asked questions

Is the WP10-6 model AGM? What does this technology offer?

Yes. The WP10-6 from Long uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.

How do I fit the WP10-6 model in my device?

In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.

What is the service life of the WP10-6 model?

Expected lifespan of the Long WP10-6 is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.

What are the measurements of the WP10-6 model?

Dimensions (length × width × height) are 151×50×100 mm — also written as 151x50x100 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.

Which batteries are equivalent to the Long WP10-6?

Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.


The top-rated online battery store in Spain

  • 4.5/5 · +11,800 reviews

    Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.

    Trustpilot · verified, no filters

  • Official Varta distributor

    Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.

    World’s best-selling battery brand

  • +100,000 satisfied customers

    More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.

    They trust us and recommend us

Choose trust, choose quality, choose baterias.com.