Exide 12N14-3A · Motorcycle battery 12V 14Ah 130A
Specifications
| Brand | EXIDE |
|---|---|
| Part number | 12N14-3A |
| Voltage (V) | 12 |
| Capacity (C20) | 14Ah (c20) |
| Technology | Lead-acid |
| Length | 135.00 cm |
| Width | 90.00 cm |
| Height | 165.00 cm |
| Weight | 4.60 Kgs |
€61.20
VAT included
Exide 12N14-3A 12V 14Ah 130A is a sealed motorcycle battery ready to fit, with the JIS reference your mechanic recognises at a glance. Vibration-resistant, keeps voltage during the winter off-season and cranks first time when you take it out for a ride.
Why this motorcycle battery?
- Same JIS referenceas your bike's original — fits first time
- Sealed and ready to useno acid handling, no refills
- Survives winter storageholds charge through long off-season
JIS code
12N14-3A
Voltage
12 V
Capacity
14 Ah
Cold cranking
130 A
Dimensions
135×90×165 mm
Technology
Lead-acid
Polarity
Positive on the right
Weight
4,6 kg
Model
EXIDE MOTO CONVENTIONAL 12V
Mfr. reference
12N14-3A
Motorcycle battery Exide 12N14-3A Moto Convencional 14Ah 130A 12V
12VVoltage
14AhCapacity
130ACold cranking
4.60kgWeight
With 14 Ah at 12 V and 130 A of cold cranking current (EN), the Exide 12N14-3A with conventional lead-acid technology replaces the original battery of motorcycles, scooters, quads and personal watercraft. It measures 135 × 90 × 165 mm and the positive terminal on the right, the format sought by anyone replacing a 14 Ah battery in motorcycles.
- Same JIS code as the original battery: fits first time.
- Conventional lead-acid: the most proven and economical technology.
- Energetic cranking for high-compression engines.
- Resistant to the vibration typical of two wheels.
What the Exide 12N14-3A is for
The Exide 12N14-3A is a common replacement in motorcycles, scooters, quads and personal watercraft. If your bike spends the winter standing, a trickle charger stops it reaching spring flat. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 4.60 kg, M08 terminals and B0 hold-down.
Size, terminals and hold-down of the Exide 12N14-3A
It has external dimensions of 135 × 90 × 165 mm and weighs 4.60 kg. The positive terminal on the right decides which side the cables end up on: it is the detail that causes most buying mistakes, so check it before ordering. It uses a B0 hold-down and M08 terminals, the system that anchors and connects it in the vehicle. For a direct replacement, the current battery tray must accept these dimensions and the same terminal layout; otherwise adapters will be needed or the hold-down will change.
What Exide does differently
Exide is one of the world's largest battery manufacturers and an original-equipment supplier to many car makers. Its European plants produce starter, industrial and leisure batteries under original-equipment quality controls. At baterias.com we work directly with the manufacturer or its official distributor: real stock, brand-new product and official warranty.
The Exide 12N14-3A: Moto Convencional range and conventional lead-acid technology
The Moto Convencional is the Exide range the 12N14-3A belongs to: it shares the same construction and quality criteria with the rest of the series, and varies in capacity and format to suit each vehicle.
Conventional lead-acid is the benchmark against which other technologies are compared: good cranking current, great tolerance to alternator charging and the best price per amp-hour.
How to make it last longer
On batteries with filler caps, check the electrolyte level and top up only with distilled water. Check the resting voltage before the season (above 12.6 V on a charged battery) and make sure the terminals are clean and tight.
Manufacturer's warranty
The Exide 12N14-3A comes with the manufacturer's official warranty. The warranty does not cover discharge through prolonged inactivity: if the bike stands for months, use a trickle charger.
When you get it and how to return it
Same-day dispatch from our warehouse for in-stock orders placed before 6:00 pm: 24-48 working hours in mainland Spain and Portugal, 3 to 5 days in the islands and the rest of Europe. Returns are accepted for 14 days if the battery has not been used (free collection on the Iberian mainland). You will receive tracking by email.
BCOM-EXIDE-12N14-3A
Data sheet
- Brand
- EXIDE
- Reference
- 12N14-3A
- Model
- EXIDE MOTO CONVENCIONAL 12V
- Voltage (V)
- 12
- Length
- 135.00 cm
- Width
- 90.00 cm
- Height
- 165.00 cm
- Weight
- 4.60 Kgs
- Technology
- Lead-acid
- EAN
- 3661024033381
- Terminal layout
- Positive terminal on the right
- Terminal type
- M08
- Hold-down
- B0
- Cold cranking amps (EN)
- 130A
- Capacity (C20)
- 14Ah (c20)
Specific References
- EAN13
- 3661024033381
- MPN
- 12N14-3A
Codes and references Exide 12N14-3A
| Brand | Exide · see all batteries Exide |
|---|---|
| Manufacturer range | EXIDE MOTO CONVENCIONAL 12V |
| Manufacturer reference (MPN) | 12N14-3A |
| EAN-13 barcode | 3661024033381 |
| Dimensions (length × width × height) | 135 × 90 × 165 mm (135x90x165) |
Recommended accessories
How to change the battery
Guide to replace your motorcycle battery in 10-15 minutes. Motorcycle batteries are light (2-5 kg) and usually need an 8 mm wrench.
Step 1. Prepare the vehicle
Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.
Step 2. Locate the battery compartment
On motorcycles it is usually under the seat, in the rear cowl or behind a side panel. Check the manual — access varies a lot between models.
Step 3. Disconnect the negative (−) terminal
Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Loosen the hold-down clamp or the straps that secure it. Lift the battery carefully — typical weight 2-5 kg. Check the terminals are not corroded before fitting the new one.
Step 6. Install the new battery
Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.
Step 7. Connect the cables
Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.
Step 8. Verify the engine starts
Close the bonnet. Start the engine to confirm everything works. On cars with Start-Stop or a BMS, you may need to register the battery via OBD so the alternator applies the correct charging profile.
Frequently asked questions
How is the Exide 12N14-3A battery installed in the vehicle?
In most motorcycles it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On motorcycles with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How long does the Exide 12N14-3A battery last?
Expected lifespan of the Exide 12N14-3A is 4 to 6 years in regular motorcycle use without Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What are the dimensions of the Exide 12N14-3A battery?
Dimensions (length × width × height) are 135×90×165 mm — also written as 135x90x165 mm — following the European DIN standard. Always measure the space in your motorcycle before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Is the 12N14-3A valid for my vehicle?
Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The 12N14-3A typically fits a wide range of European vehicles thanks to its standard DIN case format.
What are the equivalents of the 12N14-3A model?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop motorcycles. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.