Exide EV1300 · Marine battery 12.8V 100Ah LifePo4 BT

Batería Exide EV1300 100Ah 1300Wh - 1
search
  • Batería Exide EV1300 100Ah 1300Wh - 1

Specifications

BrandEXIDE
Part numberEV1300S
Voltage (V)12.8
Capacity (C20)100Ah (c20)
TechnologyLifePo4 BT
Length307.00 cm
Width170.00 cm
Height216.00 cm
Weight11.70 Kgs
See the full specifications →
€1,570.70
VAT included
Quantity

  • 24-48h delivery
  • 14-day returns
  • Secure payment
  • +12,000 reviews

Brand: EXIDE batteries Part number: EV1300S

Exide EV1300 12V 100Ah is a LiFePO4 lithium service battery for boats, designed to power onboard loads (fridge, fishfinder, GPS, lights, inverter) through deep daily discharges. It is not a starting battery: it replaces the lead-acid service bank at around 60 % less weight.

Why this lithium marine battery?

  • Deep-cycle service bankdaily discharges to 80 % with no capacity loss
  • 60 % less weight on boardthe same energy as lead-acid in far less space
  • Built-in BMS, maintenance freeprotects against overcharge, over-discharge and short circuit
Voltage
12 V
Capacity
100 Ah C20
Dimensions
308×168×211 mm
Technology
LifePo4 BT
Polarity
Positive on the left
Weight
11,7 kg
Model
EXIDE MARINE AND LEISURE LI-Ion
Logo Exide

Marine battery Exide EV1300 MARINE AND LEISURE LI-Ion 100Ah 12.8V

12.8VVoltage
100AhCapacity
11.70kgWeight

The Exide EV1300 with LiFePO4 lithium technology is a marine battery with 100 Ah for motor and sailing boats, both for engine starting and onboard services. Measuring 307 × 170 × 216 mm, it is the direct replacement for boats fitted from the factory with a 100 Ah battery of this format.

  • Sealed: no spills or gases in the locker.
  • Resistant to humidity and salt air.
  • Built-in BMS protecting the battery and the vehicle.
  • Ready for starting outboard and inboard engines.

Dimensions, polarity and mounting

The Exide EV1300 is made in the 307 × 170 × 216 mm format and weighs 11.70 kg. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.

What the Exide EV1300 is for

The Exide EV1300 is designed for motor and sailing boats, both for engine starting and onboard services. If it is your starter battery, run the services from a separate battery; if it is a service battery, avoid routinely discharging it beyond 50%. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 11.70 kg.

The Exide EV1300: MARINE AND LEISURE LI-Ion range and LiFePO4 lithium technology

Within the Exide catalogue, the MARINE AND LEISURE LI-Ion series groups the references designed for this use. The EV1300 is the 100 Ah model of that family, with the same performance as its siblings in other sizes.

A LiFePO4 battery starts with the same nominal voltage as a lead-acid one but with far less weight and a service life several times longer. It requires a lithium-compatible charger.

Why choose Exide batteries

With more than a century of history, Exide Technologies manufactures automotive, marine, motorcycle and industrial batteries in Europe. Its presence as original equipment on assembly lines vouches for the quality of every reference. All the Exide batteries in our catalogue are genuine product, recently manufactured and covered by the manufacturer's warranty.

Official warranty

The Exide EV1300 comes with the manufacturer's official warranty against manufacturing defects. Deep discharge from winter lay-up without charging is not covered.

Care and maintenance

As a service battery, avoid routine discharges below 50% to extend its cycle life. Protect the terminals with dielectric grease and check the fixing: vibration and swell loosen connections.

When you get it and how to return it

Order before 6:00 pm with stock available and it leaves today: mainland Spain and Portugal receive it in 24-48 working hours, the islands and the rest of the EU in 3 to 5 days. You have 14 days to return it if it has not been installed, with free collection on the mainland, and shipment tracking by email.

BCOM-EXIDE-EV1300

Data sheet

Brand
EXIDE
Reference
EV1300
Model
EXIDE MARINE AND LEISURE LI-Ion
Voltage (V)
12.8
Length
307.00 cm
Width
170.00 cm
Height
216.00 cm
Weight
11.70 Kgs
Technology
LifePo4 BT
Capacity (C20)
100Ah (c20)
Case type
D31
Energy (Wh)
1300

Specific References

EAN13
3661024037983
MPN
EV1300S

Codes and references Exide EV1300S

Brand Exide · see all Exide batteries
Manufacturer range EXIDE MARINE AND LEISURE LI-Ion
Manufacturer part number (MPN) EV1300S
EAN-13 barcode 3661024037983
Dimensions (length × width × height) 308 × 168 × 211 mm (308x168x211)

Recommended accessories — complement the Exide EV1300 with a charger or tester

How to change the battery

Guide to replace a marine battery (cranking or house) in 20-30 minutes. Moisture and vibration in marine environments require reinforced hold-downs and sealed copper terminals.

⏱ 20-30 min🛠 Tools: 10 mm or 13 mm wrench (depending on terminal) · Protective gloves
  1. Step 1. Prepare the vehicle

    Park on a flat surface, switch off the engine and remove the key. Make sure all lights and electrical accessories are off. Wait 1-2 minutes before starting.

  2. Step 2. Locate the battery compartment

    Usually under the passenger bench, engine room or a dedicated ventilated compartment. Verify the compartment is dry and well ventilated before opening.

  3. Step 3. Disconnect the negative (−) terminal

    Use the 10 mm wrench to loosen the negative cable nut (black, marked −) and remove the cable from the post. Move it aside so it cannot touch any bodywork.

  4. Step 4. Disconnect the positive (+) terminal

    Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.

  5. Step 5. Remove the old battery

    Marine batteries are heavy (15-50 kg). If it has rope handles, use them; otherwise have a carry strap ready. Secure the new one with metal hold-downs (not plastic) to resist sea-state vibration.

  6. Step 6. Install the new battery

    Place the battery in the same orientation as the old one (positive terminal on the same side). Tighten the hold-down clamp firmly.

  7. Step 7. Connect the cables

    Connect the positive (+) terminal first, then the negative (−). Tighten the nuts with the wrench until each terminal does not move. Apply anti-spark grease if you have any.

  8. Step 8. Verify circuit + water protection

    Apply dielectric grease on terminals to prevent salt-air corrosion. Check the engine charging circuit delivers 13.8-14.4 V at 2,000 rpm.

Frequently asked questions

How is the Exide EV1300S battery installed in the vehicle?

In most boats it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On boats with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.

What is the service life of the EV1300S model?

Expected lifespan of the Exide EV1300S is 10 to 15 years, equivalent to 3,000-5,000 cycles at 80% DoD. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.

What are the dimensions of the Exide EV1300S battery?

Dimensions (length × width × height) are 308×168×211 mm — also written as 308x168x211 mm — following the European DIN standard. Always measure the space in your boat before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.

Is the EV1300S valid for my vehicle?

Three options to confirm: 1) enter your number plate in the finder (DGT/DVLA/KBA auto-detect your model and engine); 2) check the "Compatible vehicles" tab on this page, where we list every vehicle verified by our technical team; 3) if you cannot find your model, message us on WhatsApp with brand, model, engine and year — we reply during business hours (Mon–Fri 10:00–13:30 and 16:40–18:00 (Spanish time, CET)). The EV1300S typically fits a wide range of European vehicles thanks to its standard DIN case format.

What are the equivalents of the EV1300S model?

Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop boats. See the "Equivalents" section to view recommended options at the same performance level.


The top-rated online battery store in Spain

  • 4.5/5 · +12,000 reviews

    Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.

    Trustpilot · verified, no filters

  • Official Varta distributor

    Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.

    World’s best-selling battery brand

  • +100,000 satisfied customers

    More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.

    They trust us and recommend us

Choose trust, choose quality, choose baterias.com.