Ritar RL23000 · Stationary UPS battery 2V 3000Ah AGM
Specifications
| Brand | RITAR |
|---|---|
| Part number | RL23000 |
| Voltage (V) | 2 |
| Capacity (C20) | 3000 |
| Capacity (C10) | 3000Ah (c10) |
| Capacity (C5) | 2665Ah (c5) |
| Technology | AGM |
| Length | 696.00 mm |
| Width | 340.00 mm |
€1,695.95
VAT included
4,99/5★★★★★6 reviewsVerified purchases
- ★★★★★Cesar Gallego:
Tardó un poco más de lo habitual porque eran 8 baterias y vinieron por mensajería industrial.
- ★★★★★Emilio Cruz:
Tardó un poco más de lo habitual porque eran 8 baterías y vinieron por mensajería industrial.
- ★★★★★David Moya:
Me atendieron muy bien
Ritar RL23000 2V 3000Ah is a stationary battery for backup power systems: UPS, alarms, telecom and emergency lighting. Long float-life under permanent charge and instant response to mains outages with no noticeable voltage drop.
Why this stationary battery?
- Instant responsewhen the mains drop, no voltage dip
- Long life under 24/7 chargeoptimised for permanent service
- Compatible with your systemexisting UPS units and alarm control panels
Voltage
2 V
Capacity
3000 Ah
Dimensions
696×340×342 mm
Technology
AGM
Weight
170 kg
Model
RITAR RL
Stationary battery Ritar RL23000 RL 3,000Ah 2V
2VVoltage
3,000AhCapacity
170kgWeight
Designed for UPS, alarms, telecoms and emergency lighting, the Ritar RL23000 from the RL range offers 3,000 Ah with AGM technology on permanent float charge. Measuring 696 × 340 × 342 mm, it is the direct replacement for UPS, alarm and emergency systems fitted from the factory with a 3,000 Ah battery of this format.
- Low self-discharge and high reliability.
- Standard format for UPS and emergency systems.
- AGM: faster recharging and better cycle resistance than a conventional battery.
- Instant response to mains failures.
What the Ritar RL23000 is for
Designed for UPS, alarms, telecoms and emergency lighting, the Ritar RL23000 is sealed, gas-free and suitable for technical cabinets and offices. Check that it matches your current battery in dimensions, terminals and hold-down: this reference has a weight of 170 kg and F10(M8) terminals.
Dimensions, polarity and mounting
The Ritar RL23000 is made in the 696 × 340 × 342 mm format and weighs 170 kg. It uses F10(M8) terminals, the system that anchors and connects it in the vehicle. Before replacing it, measure your current battery tray: if all three dimensions and the terminal positions match, the swap is direct and needs no adapters.
The Ritar RL23000: RL range and AGM technology
The RL23000 is part of the Ritar RL range. Choosing the right reference within the series comes down to capacity, dimensions and terminals: technology and quality are common to the whole family.
AGM means the acid is held in a glass mat instead of floating free. That is why the battery can be installed in the cabin without gases, survives more cycles and recovers its charge quickly.
Ritar: the maker behind the RL23000
With more than twenty years making sealed lead batteries, Ritar offers general-purpose, long-life, high-rate and front-terminal ranges for every stationary application. We guarantee that every Ritar arrives new, charged and with the manufacturer's full warranty.
Manufacturer's warranty
The Ritar RL23000 comes with the manufacturer's official warranty against manufacturing defects. If it fails through a defect within the warranty period, we replace it at no cost to you.
Usage and maintenance tips
Replace all the batteries in the set at once and avoid environments continuously above 25 °C. Charge with a charger that has an AGM mode: it limits the voltage and protects the glass-fibre separators.
Delivery times and returns
Orders placed before 6:00 pm with the battery in stock ship the same day. Delivery in mainland Spain and Portugal takes 24-48 working hours; for the Balearic and Canary Islands and the rest of the European Union allow 3 to 5 working days. You have 14 days to return an unused battery; in mainland Spain and Portugal collection is free. We email you the tracking number as soon as the parcel ships.
BCOM-RITAR-RL23000
Data sheet
- Brand
- RITAR
- Reference
- RL23000
- Model
- RITAR RL
- Voltage (V)
- 2
- Length
- 696.00 mm
- Width
- 340.00 mm
- Height
- 342.00 mm
- Weight
- 170 Kgs
- Technology
- AGM
- Terminal type
- F10(M8)
- Capacity (C20)
- 3000
- Capacity (C10)
- 3000Ah (c10)
- Capacity (C5)
- 2665Ah (c5)
Specific References
- MPN
- RL23000
4,99/5
Verified purchasesLatest verified reviews
★★★★★Cesar Gallego
19/09/2026Rapidez en la entrega
Tardó un poco más de lo habitual porque eran 8 baterias y vinieron por mensajería industrial.
★★★★★Emilio Cruz
07/07/2026Todo muy rápido y bien
Tardó un poco más de lo habitual porque eran 8 baterías y vinieron por mensajería industrial.
★★★★★David Moya
15/02/2026Servicio extraordinario
Me atendieron muy bien
★★★★★Francisco Javier Flores
02/02/2026Trato correcto
Normalmente no compro en línea, pero ellos se encargan de dar un trato cercano y profesional. No me arrepiento de haber comprado en esta web
Recommended accessories
How to change the battery
Guide to replace a cyclic battery (12V 4-30Ah) for UPS, mobility scooter, alarm or backup device. Estimated time 10-15 minutes. Important: discharge residual voltage before handling.
Step 1. Power off and unplug the device
Unplug the device (UPS, scooter, alarm) and leave it off for at least 30 seconds to discharge residual capacitor voltage. Work on an insulating surface.
Step 2. Locate the battery compartment
Usually under the seat (mobility scooter/wheelchair), in the rear module of the UPS, or behind a side panel with screws. Check the device manual for unusual models.
Step 3. Disconnect the negative (−) first
With insulated gloves, remove the negative (−) cable first. Some UPS have protection fuses — note their position before removing.
Step 4. Disconnect the positive (+) terminal
Repeat with the positive cable (red, marked +). Important: never let a terminal touch metal of the car while the other is still connected.
Step 5. Remove the old battery
Typical weight 1-15 kg depending on capacity. Many cyclic batteries are AGM/GEL — keep them upright. Do NOT invert the battery: even sealed, residue may exist.
Step 6. Fit the new battery
Same orientation and type (AGM, GEL or flooded). Polarity must match the device, not a chassis (this is not a car). Make sure terminals do not touch metal parts of the compartment.
Step 7. Connect the positive (+) first
On cyclic devices the order is reversed compared to cars: positive (+) first, negative (−) afterwards. Tighten without forcing — the plastic terminal housing of cyclic batteries damages easily.
Step 8. Initial charge before first use
Cyclic batteries ship at 60-80%. Before first use, connect the device charger for 8-12 hours (or use an AGM/GEL smart charger if available). This avoids short cycles and extends lifespan.
Frequently asked questions
Is the Ritar RL23000 an AGM battery and what are the benefits of AGM?
Yes. The RL23000 from Ritar uses AGM (Absorbent Glass Mat) technology: a sealed lead-acid battery where the electrolyte is absorbed in a glass-fibre mat. It withstands more charge/discharge cycles than a conventional one, handles heat better and is the required technology for devices with advanced Start-Stop and regenerative braking. Expected lifespan: 5-8 years under normal conditions.
How do I fit the RL23000 model in my device?
In most devices it fits in 15-30 minutes with a 10 mm wrench; if the battery is under the seat or in the boot the time can double. See the step-by-step guide on this page. Quick summary: 1) switch off the engine and remove the key; 2) locate the original battery (engine bay, boot or under seat); 3) disconnect the negative (−) terminal first, then the positive (+); 4) loosen the hold-down clamp and remove the old battery; 5) fit the new one in the same orientation — match the polarity shown on the product sheet; 6) connect the positive (+) first, then the negative (−). On devices with Start-Stop or BMS, register the battery via OBD so the alternator applies the correct charging profile.
How long does the Ritar RL23000 battery last?
Expected lifespan of the Ritar RL23000 is 5 to 8 years in mild-climate device use with Start-Stop. In cold regions it drops slightly due to cold-start stress; in very hot regions it also drops because of electrolyte evaporation. To extend its life: avoid deep discharges (headlights on with engine off), have the alternator checked yearly, and keep the battery clean and properly secured.
What size is this battery?
Dimensions (length × width × height) are 696×340×342 mm — also written as 696x340x342 mm — following the European DIN standard. Always measure the space in your device before buying: even one extra millimetre can prevent the hold-down clamp from closing. The height shown includes the terminals.
Which interchangeable batteries are there for this one?
Directly interchangeable batteries (same dimensions, same polarity, same Ah and CCA) are the OEM equivalents from leading brands: Bosch, Tudor, Exide and, depending on the model, Banner or Yuasa. Exact equivalence depends on technology — an EFB cannot be replaced with a conventional battery in Start-Stop devices. See the "Equivalents" section to view recommended options at the same performance level.
The top-rated online battery store in Spain
-
Audited by Trustpilot, no filters, no edits. The top-rated battery store in Spain.
Trustpilot · verified, no filters
-
Official Varta distributor
Official Varta wholesale distributor. 100% genuine batteries, recently manufactured, best price and no middlemen.
World’s best-selling battery brand
-
+100,000 satisfied customers
More than 100,000 customers already trust baterias.com — and recommend us to their friends and family.
They trust us and recommend us
Choose trust, choose quality, choose baterias.com.